Aiutino Cisco 827 ADSL Flat 4Mbit Tin.it Configurazione

Tutto ciò che ha a che fare con la configurazione di apparati Cisco (e non rientra nelle altre categorie)

Moderatore: Federico.Lagni

Rispondi
Yatta
n00b
Messaggi: 5
Iscritto il: mer 04 gen , 2006 3:53 pm

Ciao a tutti!! Mi sono appena iscritto a questo forum per chiedervi un aiuto :oops: tanto per cambiare direte voi :cry:
Vi giuro che ho letto a destra e a manca, ho copiato svariate configurazioni postate in questo forum...ma non cambia nulla...insomma siete la mia ultima risorsaaaaaa :D

Ho un router cisco 827 (con un linea ADSL 4Mb Tin.it) che funzionava alla perfezione utilizzando le impostazioni trovate sul sito di tiscali
Dopo un periodo di disuso non riesco a farlo funzionare, in sostanza trova la rete adsl ma non si connette alla rete tin.it e non gli viene assegnato ip.

Nel Web setup in interface summary c'è scritto:
LAN SUMMARY
--------------------
Interface Status : up
Interface IP Address : 10.10.10.1
Interface Subnet Mask : 255.0.0.0
DHCP Server Enabled : Yes
DHCP Network Address : 10.0.0.0
Default Router : 10.10.10.1
DHCP Lease : 1 Day
Primary DNS Server : Not configured
Secondary DNS Server : Not configured

WAN SUMMARY
----------------------
WAN IP Address : Not Configured
Interface Status : up
Line Protocol : up
VPI/VCI Number : 8/35
PPP User Name : Not Assigned
Automatic IP address assignment : No
DSL UP Stream Speed : 320 kbps
DSL Down Stream Speed : 4832 kbps
E la configurazione é questa:
!
version 12.1
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Router
!
enable secret 5 $1$YdyB$C4CtgeACb8QbmA07mb782/
enable password xxxx
!
username Router password 0 xxxxxxxx
username Cisco privilege 15 password 0 CRWS
!
!
!
!
ip subnet-zero
no ip routing
!
ip dhcp pool CLIENT
network 10.0.0.0 255.0.0.0
default-router 10.10.10.1
!
!
!
!
!
!
interface Ethernet0
ip address 10.10.10.1 255.0.0.0
ip nat inside
no ip route-cache
no ip mroute-cache
!
interface ATM0
no ip address
no ip route-cache
no ip mroute-cache
no atm ilmi-keepalive
pvc 8/35
encapsulation aal5mux ppp dialer
dialer pool-member 1
!
bundle-enable
dsl operating-mode auto
!
interface Dialer0
ip address negotiated
ip nat outside
encapsulation ppp
dialer pool 1
ppp authentication chap pap callin
ppp chap hostname [email protected]
ppp chap password 7 00124755120A08125E32
ppp pap sent-username [email protected] password 7 10585D4A1346111F5D17
!
ip nat inside source list 1 interface Dialer0 overload
ip classless
ip route 0.0.0.0 0.0.0.0 Dialer0
ip http server
!
access-list 1 permit 10.10.10.0 0.0.0.255
snmp-server engineID local 00000009020000036BDBFF9B
snmp-server community public RO
!
line con 0
transport input none
stopbits 1
line vty 0 4
exec-timeout 30 0
password xxxxxxxxx
login local
length 0
!
scheduler max-task-time 5000
end
Mi sareste di grande aiuto...grazie :D
Avatar utente
spooke
Cisco enlightened user
Messaggi: 136
Iscritto il: sab 05 mar , 2005 10:18 pm
Località: Milano
Contatta:

verifica lo stato delle interfacce (non devono essere un shut down)
comando da usare in privileged mode: show interface NOME INTERFACCIA

fammi sapere
Yatta
n00b
Messaggi: 5
Iscritto il: mer 04 gen , 2006 3:53 pm

grazie per l'interessamento :D
Ethernet0 is up, line protocol is up
Hardware is PQUICC Ethernet, address is 0003.6bdb.ff9b (bia 0003.6bdb.ff9b)
Internet address is 10.10.10.1/8
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 2000 bits/sec, 4 packets/sec
5 minute output rate 1000 bits/sec, 3 packets/sec
204 packets input, 15629 bytes, 0 no buffer
Received 41 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
146 packets output, 12417 bytes, 0 underruns(0/0/0)
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
ATM0 is up, line protocol is up
Hardware is PQUICC_SAR (with Alcatel ADSL Module)
MTU 1500 bytes, sub MTU 1500, BW 640 Kbit, DLY 80 usec,
reliability 76/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Keepalive not supported
Encapsulation(s): AAL5, PVC mode
11 maximum active VCs, 2 current VCCs
VC idle disconnect time: 300 seconds
Last input never, output 00:00:04, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: Per VC Queueing
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
41 packets input, 1499 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
21 packets output, 294 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
Dialer0 is up, line protocol is up (spoofing)
Hardware is Unknown
Internet address is 82.51.130.72/32
MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload
Encapsulation PPP, loopback not set
DTR is pulsed for 1 seconds on reset
Interface is bound to Virtual-Access1
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:03:02
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
59 packets input, 2230 bytes
21 packets output, 614 bytes
Bound to:
Virtual-Access1 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 56 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
Interface is bound to Dialer0 (Encapsulation PPP)
LCP Open
Listen: CDPCP
Open: IPCP
Bound to ATM0 VCD: 1, VPI: 8, VCI: 35
Cloned from Dialer0
Last input 00:00:03, output never, output hang never
Last clearing of "show interface" counters 00:04:13
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
93 packets input, 3283 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
39 packets output, 1170 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
comunque anche se qui risulta esserci un ip wan, sul web setup c'é not assigned come dicevo nel primo post, e comunque non riesco a navigare
Che siano i dns da inserire? Ma quali sono? Facendo la ricerca automatica nel web setup mi dice che non riesco a trovarli e poi me ne indica due sulla scelta manuale.

Ho provato la configurazione websetup in tre occasioni con dns diversi ogni volta, quello della tin.it classico la prima volta, poi 206.141.192.243 e una terza volta 206.13.28.12
Yatta
n00b
Messaggi: 5
Iscritto il: mer 04 gen , 2006 3:53 pm

non sapreste proprio dove sbaglio?
telma
Cisco power user
Messaggi: 119
Iscritto il: mar 27 dic , 2005 12:13 pm
Località: Alghero

access-list 1 permit 10.10.10.0 0.0.0.255

OCCHIO !!!!!

interface Ethernet0
ip address 10.10.10.1 255.0.0.0
ip nat inside

non influenza MA !
La vita e piena di problemi !!!
Yatta
n00b
Messaggi: 5
Iscritto il: mer 04 gen , 2006 3:53 pm

scusami, ma non capisco...che problema é?
scarvello
n00b
Messaggi: 1
Iscritto il: gio 12 gen , 2006 1:30 am

Ho avuto lo stesso problema da 15-12-2005 fino al 01-01-2006.
Credo sia dovuto a problemi della rete interbusiness.
Per oltre 20 giorni ho ottenuto " WAN IP NUMBER unassigned".
Ti premetto che l'assegnazione dell'ip del mio contratto ADSL flat è dinamica quindi credo sia stato un problema di interbusiness. Infatti si è risolto senza alcuna modifica al mio running-config.
Bye
Yatta
n00b
Messaggi: 5
Iscritto il: mer 04 gen , 2006 3:53 pm

bho io sono sempre al punto di prima :cry:
Segolas
Cisco fan
Messaggi: 33
Iscritto il: lun 28 nov , 2005 6:27 pm

mmm, so che sembra una caxxata, ma a volte telefonare al "coll senter" serve, almeno ti sanno dire cosa è che non và.

Noi a casa abbiamo dovuto chiamare all'assistenza di aliceadsl, e alla 3 telefonata (e in seguito alla minaccia di disdire per disservizio), miracolosamente la rete è tornata.
Rispondi