Ciao a tutti
sto configurando un cisco 2811 con cme 4.0.0 risco a ricevede telefonate ma non ad inviarle (non ho ancora impostato translation-role quindi ricevo chiamate da un solo telefono)
i dial-peer sono
dial-peer voice 2 pots
description ** BRI pots dial-peer **
destination-pattern 0T
port 0/0/0
!
dial-peer voice 3 pots
description ** BRI pots dial-peer **
incoming called-number .
direct-inward-dial
port 0/0/0
!
dial-peer voice 4 pots
description ** BRI pots dial-peer **
destination-pattern 0118
port 0/0/1
forward-digits 3
!
dial-peer voice 5 pots
description ** BRI pots dial-peer **
destination-pattern 0T
direct-inward-dial
port 0/0/1
!
dial-peer voice 6 pots
description ** BRI pots dial-peer **
incoming called-number .
direct-inward-dial
port 0/0/1
e le interfacce bri sono interface BRI0/0/0
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
!
interface BRI0/0/1
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
qualche idea?
Grazie a tutti
ccme + vic2-2bri
Moderatore: Federico.Lagni
