Ho già dato un occhio all'altro thread di !gabri! ma non mi è stato utile....
SHOW RUN
Codice: Seleziona tutto
Current configuration : 2188 bytes
!
version 12.3
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname XXX
!
boot-start-marker
boot-end-marker
!
no logging buffered
enable secret 5 $1$7LBN$rOsljx0Mjv1tmm.9aJXLt1
enable password XXX
!
no aaa new-model
ip subnet-zero
no ip routing
!
!
ip dhcp excluded-address 192.168.0.250
!
ip dhcp pool CLIENT
network 192.168.0.0 255.255.255.0
default-router 192.168.0.250
dns-server 62.211.69.150 212.48.4.15
domain-name tin.it
lease 0 2
!
!
ip name-server 62.211.69.150
ip name-server 212.48.4.15
ip ips po max-events 100
!
!
!
!
!
!
!
interface Ethernet0
description $ETH-LAN$
ip address 192.168.0.250 255.255.255.0
ip nat inside
ip virtual-reassembly
no ip route-cache
ip tcp adjust-mss 1412
hold-queue 100 out
!
interface ATM0
no ip address
no ip route-cache
no atm ilmi-keepalive
dsl operating-mode auto
!
interface ATM0.1 point-to-point
no ip route-cache
pvc 8/35
pppoe-client dial-pool-number 1
!
!
interface FastEthernet1
no ip address
duplex auto
speed auto
!
interface FastEthernet2
no ip address
duplex auto
speed auto
!
interface FastEthernet3
no ip address
duplex auto
speed auto
!
interface FastEthernet4
no ip address
duplex auto
speed auto
!
interface Dialer0
ip address negotiated
ip mtu 1452
ip nat inside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication pap callin
ppp pap sent-username [email protected] password 0 XXX
!
ip classless
!
ip http server
no ip http secure-server
ip nat inside source list 1 interface Dialer0 overload
!
!
access-list 1 remark INSIDE_IF=Ethernet0
access-list 1 remark SDM_ACL Category=2
access-list 1 permit 192.168.0.0 0.0.0.255
dialer-list 1 protocol ip permit
snmp-server community public RO
snmp-server enable traps tty
!
control-plane
!
!
line con 0
no modem enable
transport preferred all
transport output all
line aux 0
transport preferred all
transport output all
line vty 0 4
exec-timeout 120 0
password XXX
login
length 0
transport preferred all
transport input all
transport output all
!
scheduler max-task-time 5000
end
Codice: Seleziona tutto
Dialer0 is up, line protocol is up (spoofing)
Hardware is Unknown
Internet address will be negotiated using IPCP
MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 1 seconds on reset
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:11:06
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 42 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
12 packets input, 344 bytes
11 packets output, 170 bytes
Codice: Seleziona tutto
Ethernet0 is up, line protocol is up
Hardware is PQUICC Ethernet, address is 000f.8fe8.0711 (bia 000f.8fe8.0711)
Description: $ETH-LAN$
Internet address is 192.168.0.250/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Mb/s
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:13:27, output 00:00:03, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/100 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
15 packets input, 1752 bytes, 0 no buffer
Received 15 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
106 packets output, 10158 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Un altra cosa, come faccio a connettermi con filezilla server in modo da poter inviare una configurazione completa in un colpo? ho tolto la stringa no ftp-server write-enable ma non riesco cmq, che devo mettere su filezilla? ip, porta (la 21 immagino) e pass giusto no?
GRAZIE A TUTTI!!!!
