Esame CVoice 642-436

[Beluga84]

Cia Ragazzi,
mi sto preparando per l'esame del cvoice 642-436, c'è qualcuno che l'ha fatto recentemente e può darmi qualche dritta?
Sostanzialmente vorrei sapere se e quanti laboratori ci sono nell'esame.

Grazie mille

[roby1977]

zero lab.. solo domande teoriche, quando l'ho fatto io (circa un anno fa)

[beppevip]

Ciao,
io sapevo che un lab ci fosse... ma sicuramente mi confondo con la CCNA Voice.


Beppe

[Beluga84]

Ciao,
io sapevo che un lab ci fosse... ma sicuramente mi confondo con la CCNA Voice.


Beppe

Grazie per l'aiuto ragazzi!
Probabilmente non ricordi male, infatti in giro per i forum ho trovato questo laboratorio, ma è davvero semplice, bisogna giusto mettere un paio di dial peer, uno pots e l'altro voip. Metto qui per chiunque si trovasse nella mia situazione il testo del laboratorio.
Ciuaz

You're a CCNP certified employee at Deutsche Telekom. You are working with the abc .com
Telephone Company, in Rammstein Germany, to assist them to set up a simple configuration to
demonstrate an FXS-to-PSTN connection across an IP network. The Ethernet interfaces and
routing protocols are already configured on both routers. The R1 router will act as gateway to the
PSTN to the PSTN and is correctly configured for this task. You are required to add the voice
portion to the R2 router. Configure the pots and VoIP dial peers and insure that the pots telephone
on the R2 router can reach the PSTN connected to the R1 router. The analog telephone is
connected to voice port 1/0/0. The customer uses the access code 9 to dial out the PSTN. Insure
that the R1 and R2 recognize the dialed digits as standard E.164 numbers. The telephone number
of the pots telephone connected to the R1 router is 49648455554321. After the configuration is
complete you may click on the telephone to check your configuration. If the call is successful, you
will get a ringing message and a completed call. If the call is unsuccessful, you will get a busy
signal. The R1 router has the following configured ports: Ethernet: 0/0 172.16.1.11 255.255.255.0
To configure the router click on a host icon that is connected to a router by a serial console cable.

Explanation:
en
config t
dial- peervoice 1 pots
destination-pattern 6495551212
port1/0/0
dial- peervoice 2 voip
destination-pattern +9T
sessiontarget ipv4:172.16.1.11