CiscoForums.it

Ciao a tutti,
a seguito di un temporale il mio 837 è andato in tilt, nel senso che ha i due led ADSL txd e rxd lampeggianti ed è raggiungibile solo tramite terminale. Null'altro!!!
Pensate che sia recuperabile?
Mi dareste una mano?

No, non penso sia recuperabile. Se la ethernet è andata (salvo che non sia rimasta qualche porta buona) non potresti comunque fartene nulla. I due led che lampeggiano significano che il modem interno non prende neppure la portante. Secondo me (dato che hai parlato di temporale) è andato anche il modem ADSL interno. Ok, buttalo e ricomprane uno su ebay.

PS: io ne ho uno a disposizione di 837 + ho anche 827. Se ti interessano Private Message e ci accordiamo sul prezzo

Ciao

prima che gli faccio il funerale, ci sono tentativi possibili?

....scusami, che tipo di tentavi su "ethernet rotta" e/o "modem adsl bruciato"?? Parti da un presupposto: funzionava tutto, quindi fulmine, successivamente non funziona più nulla. Ti chiedo: che cosa vuoi fare?

in realtà non sono sicuro che il guasto sia dipeso dal temporale innanzitutto perchè era protetto da UPS e poi perchè il temporale c'è stato ieri ed il guaio oggi...

Topic pulito da post inutili

Fai così:

- collegati in seriale alla macchina
- dai il comando "sh int"

postalo qui che vediamo

ecco ciò che mi da il comando. è da tener presente che la linea adsl è al momento disconnessa

ATM0 is administratively down, line protocol is down
Hardware is PQUICC_SAR (with Alcatel ADSL Module)
MTU 1500 bytes, sub MTU 1500, BW 800 Kbit, DLY 80 usec,
reliability 0/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Encapsulation(s): AAL5 AAL2, PVC mode
10 maximum active VCs, 1024 VCs per VP, 0 current VCCs
VC Auto Creation Disabled.
VC idle disconnect time: 300 seconds
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: Per VC Queueing
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
Ethernet0 is administratively down, line protocol is down
Hardware is PQUICC Ethernet, address is 000f.8fe7.f2bd (bia 000f.8fe7.f2bd)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Mb/s
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:01:10, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/100 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
21 packets output, 6282 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
FastEthernet1 is down, line protocol is down
Hardware is FastEthernet, address is 0000.0000.0000 (bia 0000.0000.0000)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto Speed, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
FastEthernet2 is down, line protocol is down
Hardware is FastEthernet, address is 0000.0000.0000 (bia 0000.0000.0000)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
FastEthernet3 is down, line protocol is down
Hardware is FastEthernet, address is 0000.0000.0000 (bia 0000.0000.0000)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto Speed, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
FastEthernet4 is down, line protocol is down
Hardware is FastEthernet, address is 0000.0000.0000 (bia 0000.0000.0000)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto Speed, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out

X forza non va nulla...
Hai le interfaccie in administratively down...

Fai anche uno "sh run" e posta la config

eccolo...

Building configuration...

Current configuration : 853 bytes
!
version 12.3
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
!
no aaa new-model
ip subnet-zero
!
!
!
!
ip ips po max-events 100
no ftp-server write-enable
!
!
!
!
no crypto isakmp ccm
!
!
!
interface Ethernet0
no ip address
shutdown
hold-queue 100 out
!
interface ATM0
no ip address
shutdown
no atm ilmi-keepalive
dsl operating-mode auto
!
interface FastEthernet1
duplex auto
speed auto
!
interface FastEthernet2
duplex auto
speed auto
!
interface FastEthernet3
duplex auto
speed auto
!
interface FastEthernet4
duplex auto
speed auto
!
ip classless
!
ip http server
no ip http secure-server
!
!
!
!
control-plane
!
!
line con 0
no modem enable
line aux 0
line vty 0 4
!
scheduler max-task-time 5000
end

Ma la config è di un router vergine...

ho provato a cavermela da solo ed ho cominciato resettando il tutto. adesso però sono in un vicolo cieco!

E beh ci credo...
Se non hai la vecchia config inizia trovando i dati x la linea internet e lan

la vecchia conf mi pare di averla salvata con la procedura di reset ma non ho idea come fare per trovarla in quanto non so nemmeno dove cercare.
non è invece un problema per i dati internet e lan:
per il primo si tratta di una connessione con ip fisso, per il secondo l'ip del router è fisso con dhcp disattivato ed una serie di reindirizzamenti NAT, firewall disattivato (se va bene), configurazione anche tramite interfaccia grafica (almeno così era prima).

Se trovi la vecchia config è meglio cmq prova a ri-configurare il router e facci vedere la config.

In teoria x adesso basta che configuri la int interna e vedi se la raggiungi...
Se nn va quella nn vale la pena continuare