Ios 1841+hwic

[leogood]

Qualkuno saprebbe aiutarmi in merito all'ios che devo installare per poter sia avere sicurezza vpn e adsl?Nel mio router ho attualmente installata lios advsecurityk9-12.4-13 ma non vede la hwic-1asdl!!!Grazie mille in anticipo per l'aiuto

[leogood]

Invio il bootstrap
router_adsl#
System Bootstrap, Version 12.3(8r)T8, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2004 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
c1841 processor with 131072 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled


Readonly ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xc100

Initializing ATA monitor library.......
open(): Open Error = -13
loadprog: error - on file open
boot: cannot load "flash:c1841-advsecurityk9-mz.124-13.bin"

System Bootstrap, Version 12.3(8r)T8, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2004 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
c1841 processor with 131072 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled


Readonly ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xc100

Initializing ATA monitor library.......

program load complete, entry point: 0x8000f000, size: 0x1309ffc
Self decompressing the image : #################################################
################################################# [OK]

Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
0X003AA110 public buffer pools
0X00211000 public particle pools
0X00020000 Crypto module pools
0X04C8 0X00000000 UNKNOWN Card in slot 0
0X000021B8 Onboard USB

If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.

Allocating additional 7241832 bytes to IO Memory.
PMem allocated: 118489088 bytes; IOMem allocated: 15728640 bytes

Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706



Cisco IOS Software, 1841 Software (C1841-ADVSECURITYK9-M), Version 12.4(10a), RE
LEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Wed 11-Oct-06 17:25 by prod_rel_team
Image text-base: 0x600790E0, data-base: 0x61900000


This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to
[email protected].

Cisco 1841 (revision 5.0) with 115712K/15360K bytes of memory.
Processor board ID FCZ09202097
2 FastEthernet interfaces
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
31360K bytes of ATA CompactFlash (Read/Write)

%Error opening tftp://255.255.255.255/network-confg (Timed out)
%Error opening tftp://255.255.255.255/cisconet.cfg (Timed out)
%Error opening tftp://255.255.255.255/router_adsl-confg (Timed out)
%Error opening tftp://255.255.255.255/router_a.cfg (Timed out)


Press RETURN to get started!


*Mar 4 16:56:09.503: %CFG-3-CARD_NOT_SUPPORTED: Slot 0: Unknown WAN daughter ca
rd, Part# 73-9932-6, HW-Rev 8.0, Board-Rev A0, S/N FOC10312SE5sslinit fn

*Mar 4 16:56:12.463: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0 State change
d to: Initialized
*Mar 4 16:56:12.463: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0 State change
d to: Enabled
*Mar 4 16:56:15.115: %SYS-6-CLOCKUPDATE: System clock has been updated from 16:
56:15 UTC Sun Mar 4 2007 to 17:56:15 PCTime Sun Mar 4 2007, configured from cons
ole by console.
*Mar 4 16:56:15.119: %SYS-6-CLOCKUPDATE: System clock has been updated from 17:
56:15 PCTime Sun Mar 4 2007 to 17:56:15 PCTime Sun Mar 4 2007, configured from c
onsole by console.
*Mar 4 16:56:15.379: %SYS-5-CONFIG_I: Configured from memory by console
*Mar 4 16:56:15.531: %LINK-5-CHANGED: Interface FastEthernet0/1, changed state
to administratively down
*Mar 4 16:56:15.531: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthern
et0/0, changed state to up
*Mar 4 16:56:16.531: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthern
et0/1, changed state to down
*Mar 4 16:56:17.243: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state t
o up
*Mar 4 16:56:39.303: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t
ftp://255.255.255.255/network-confg) failed
*Mar 4 16:57:03.283: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t
ftp://255.255.255.255/cisconet.cfg) failed
*Mar 4 16:57:26.691: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t
ftp://255.255.255.255/router_adsl-confg) failed
*Mar 4 16:57:51.459: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t
ftp://255.255.255.255/router_a.cfg) failed
*Mar 4 16:57:51.459: %SYS-5-RESTART: System restarted --
Cisco IOS Software, 1841 Software (C1841-ADVSECURITYK9-M), Version 12.4(10a), RE
LEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Wed 11-Oct-06 17:25 by prod_rel_team
*Mar 4 16:57:51.459: %SNMP-5-COLDSTART:
router_adsl>
router_adsl>
router_adsl>SNMP agent on host router_adsl is undergoing a cold start
*Mar 4 16:57:51.775: %CRYPTO-6-ISAKMP_ON_OFF: ISAKMP is OFF
%Error opening tftp://255.255.255.255/network-confg (Timed out)
*Mar 4 16:57:57.859: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t
ftp://255.255.255.255/network-confg) failed
%Error opening tftp://255.255.255.255/cisconet.cfg (Timed out)
*Mar 4 16:58:21.339: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t
ftp://255.255.255.255/cisconet.cfg) failed
router_adsl>

[leogood]

Tutto risolto ora ho problemi con tiscali non riesco a collegarmi

[Aramis]

ciao
anche io ho un 1841 con ios Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
flash image c1841-advsecurityk9-mz.124-3g.bin.

Nuovo di pacca.. lo tiro fuori dalla scatola ed innesto 2 AdsloPots hwic.
attacco la spina, accendo il router, entro in console ma niente. Non mi rileva le due interfacce..

Confesso che pensavo fosse sufficiente inserirle...
Nei manuali non si parla di nessuna installazione logica...

faccio tutte le prove...senza..con una..scambio le hwic..nulla...

che devo fare? e' normale o si e' rotto qualcosa?

tnz

[Federico.Lagni]

Non vorrei sbagliarmi ma ad occhio e croce quell'IOS non dovrebbe bastarti per rilevare le hwic ADSL.

[Aramis]

ya

il router aveva una versione
c1841-advsecurityk9-mz.124-3g.bin
e non vedeva le schede
ho preso un'altra versione che avevo su un altro 1841 con adsl, la
c1841-advsecurityk9-mz.124-4.T6.bin
ma ancora nulla...

oggi sono riuscito ad avere accesso alla sezione download ed ho scaricato la versione c1841-advsecurityk9-mz.124-11.T1.bin del IOS
adesso me le vede...
certo che e' un po pacco comprarlo nuovo e non averlo funzionante, sopratutto se hai poca pratica con le licenze e con l'ios...

cmq grazie per l'aiuto