sto configurando i miei primi switch
Nello specifico, la rete è composta da un 1841 con ADSL e due switch (senza particolari vlan) collegati tra loro (ovviamente in gigabit?).
Cioè, visto che ho due 24p, devo fare in modo che sembri un 48p
Il primo è così:
Codice: Seleziona tutto
spanning-tree mode pvst
no spanning-tree optimize bpdu transmission
spanning-tree extend system-id
!
!
!
!
interface FastEthernet0/1
!
interface FastEthernet0/2
!
interface FastEthernet0/3
!
interface FastEthernet0/4
!
interface FastEthernet0/5
!
interface FastEthernet0/6
!
interface FastEthernet0/7
!
interface FastEthernet0/8
!
interface FastEthernet0/9
!
interface FastEthernet0/10
!
interface FastEthernet0/11
!
interface FastEthernet0/12
!
interface FastEthernet0/13
!
interface FastEthernet0/14
!
interface FastEthernet0/15
!
interface FastEthernet0/16
!
interface FastEthernet0/17
!
interface FastEthernet0/18
!
interface FastEthernet0/19
!
interface FastEthernet0/20
!
interface FastEthernet0/21
!
interface FastEthernet0/22
!
interface FastEthernet0/23
!
interface FastEthernet0/24
!
interface GigabitEthernet0/1
description VERSO ROUTER CISCO 1841
!
interface GigabitEthernet0/2
description VERSO SWITCH CISCO 2950 PORTA GIGABIT 2
!
interface Vlan1
description LAN
ip address 192.168.2.101 255.255.255.0
no ip route-cache
!
Codice: Seleziona tutto
spanning-tree mode pvst
no spanning-tree optimize bpdu transmission
spanning-tree extend system-id
!
!
!
!
interface FastEthernet0/1
!
interface FastEthernet0/2
!
interface FastEthernet0/3
!
interface FastEthernet0/4
!
interface FastEthernet0/5
!
interface FastEthernet0/6
!
interface FastEthernet0/7
!
interface FastEthernet0/8
!
interface FastEthernet0/9
!
interface FastEthernet0/10
!
interface FastEthernet0/11
!
interface FastEthernet0/12
!
interface FastEthernet0/13
!
interface FastEthernet0/14
!
interface FastEthernet0/15
!
interface FastEthernet0/16
!
interface FastEthernet0/17
!
interface FastEthernet0/18
!
interface FastEthernet0/19
!
interface FastEthernet0/20
!
interface FastEthernet0/21
!
interface FastEthernet0/22
!
interface FastEthernet0/23
!
interface FastEthernet0/24
!
interface GigabitEthernet0/1
shutdown
!
interface GigabitEthernet0/2
description COLLEGATA ALLA GIGABIT 2 DELLO SWITCH CISCO 2950
!
interface Vlan1
ip address 192.168.2.102 255.255.255.0
no ip route-cache
!
no ip http server
!
Volevo capire se basta come configurazione e sopratutto a cosa potrebbe servire configurare le singole FastEthernet con "switchport mode access".
Inoltre potrebbe servirmi mettere le Gigabit in "Trunk"?
Grazie per il supporto