blocco chiamante in ingresso

Voice su IP

Moderatore: Federico.Lagni

Rispondi
delosfast
Cisco enlightened user
Messaggi: 157
Iscritto il: ven 23 giu , 2006 2:52 pm

ciao,
ho la necessità di fare quanto in oggetto ovvero bloccare (o deviare) dei singoli numeri in ingresso,
ho cercato sul forum senza successo,
sul sito cisco ho trovato questo
http://www.cisco.com/en/US/tech/tk652/t ... html#con11

direi di averlo anche applicato (vedi sotto) ma facendo una prova dal mio cellulare passa tutto lo stesso,
dove ho toppato?

Codice: Seleziona tutto

!
boot-start-marker
boot system flash:c2600-adventerprisek9-mz.124-17.bin
boot-end-marker
!

!
!
voice call send-alert
voice rtp send-recv
!
voice service voip 
 fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none
 h323
  h225 progress-indicator local-ringback
!
!
voice class codec 1
 codec preference 1 g711alaw
!
!
!
voice class h323 1
 h225 timeout connect 360
!
!
!
!
!
!
voice source-group ********
 disconnect-cause call-reject
!
voice translation-rule 1
 rule 1 reject /328*******/
 rule 15 /^.*/ /0*******/ type any unknown plan any unknown
!
!
voice translation-profile call_block
 translate calling 1
!
!
!
!
username R1 password 7 ***********
!
!
ip ftp source-interface FastEthernet0/0
ip tftp source-interface FastEthernet0/0
! 
!
interface FastEthernet0/0
 description "LAN"
 ip address 192.168.*.254 255.255.255.0
 ip nat inside
 ip virtual-reassembly
 ip route-cache flow
 load-interval 30
 speed 100
 full-duplex
 no cdp enable
!
interface FastEthernet0/1
 description "WAN"
 ip address *.*.*.* *.*.*.*
 ip nat outside
 ip virtual-reassembly
 ip route-cache flow
 load-interval 30
 duplex auto
 speed auto
 no cdp enable
 h323-gateway voip interface
 h323-gateway voip id *********** ipaddr *.*.*.* *
 h323-gateway voip h323-id *********** 
 h323-gateway voip tech-prefix *********** 
!
no ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 FastEthernet0/1
!
!
!
!
!
!
voice-port 1/1/0
 ring cadence pattern01
 echo-cancel coverage 32
 no vad
 playout-delay nominal 100
 playout-delay mode fixed
 cptone IT
 timeouts initial 60
 timeouts interdigit 4
 timeouts call-disconnect 1
 timeouts wait-release 5
 music-threshold -70
 caller-id enable
!
voice-port 1/1/1
!
!
!
!
dial-peer cor custom
!
!
!
dial-peer voice 1 pots
 description "VOCE"
 call-block translation-profile incoming call_block
 call-block disconnect-cause incoming call-reject
 service default
 destination-pattern 0**********
 port 1/1/0
 no register e164
!
dial-peer voice 65 voip
 description "VOCE"
 max-conn 24
 destination-pattern .T
 translate-outgoing calling 1
 voice-class codec 1
 voice-class h323 1
 session target ras
 dtmf-relay h245-alphanumeric
 fax rate disable
 ip qos dscp cs5 media
 ip qos dscp cs5 signaling
 clid strip name
 no vad
!
gateway 
 timer receive-rtcp 5
 timer receive-rtp 1200
Avatar utente
IsaCab
Network Emperor
Messaggi: 349
Iscritto il: ven 18 gen , 2008 3:45 pm
Contatta:

Ciao,

fai una dial-peer dedicata come nell'esempio e riprova.

Magri metti in debug e verifica il percorso della chiamata.

Ciao Giulio
-------
Giulio Martino [ http://www.voipexperts.it ]
Avaya IP Office PA
Microsoft MCP [IsaServer]
Cisco SMB[AM,EN] - SBCS [AM,EN]
Technical Writer e Supporter di ISAServer.it
Articoli - <http://www.isaserver.it/articoli/>
Forum - <http://www.isaserver.it/forum/>
Blog - <http://blogs.dotnethell.it/isacab/>
Rispondi