dopo aver provato e riprovato sono arrivato a questo punto:
il telefono analogico collegato alla porta fxs non chiama un altro utente messagenet da il segnale di occupato come compongo la prima cifra.
il telefono riceve le chiamate sia da un altro interno messagenet che quelle dall'esterno.
l'abilitazione è freenumber (possibilità di chiamare altri utenti dello stesso fornitore)
questa è la versione dello ios:
Cisco IOS Software, C1700 Software (C1700-K9O3SV8Y7-M), Version 12.3(14)T4, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Thu 08-Sep-05 13:21 by kehsiao
ROM: System Bootstrap, Version 12.2(1r)XE1, RELEASE SOFTWARE (fc1)
1751_PPOA uptime is 4 hours, 3 minutes
System returned to ROM by reload
System restarted at 17:25:01 SUMMER-TIME Sat Sep 17 2005
System image file is "flash:c1700-k9o3sv8y7-mz.123-14.T4.bin"
Cisco 1751-V (MPC860P) processor (revision 0x300) with 114688K/16384K bytes of memory.
Processor board ID xxxx with hardware revision 0000
MPC860P processor: part number 5, mask 2
1 FastEthernet interface
1 ATM interface
2 Voice FXO interfaces
2 Voice FXS interfaces
32K bytes of NVRAM.
32768K bytes of processor board System flash (Read/Write)
Configuration register is 0x2922
questa è la configurazione:
version 12.3
no service pad
service timestamps debug uptime
service timestamps log uptime
service password-encryption
!
hostname 1751_PPOA
!
boot-start-marker
boot-end-marker
!
logging buffered 8192 notifications
logging console errors
logging monitor errors
enable password xxxxxx
!
no aaa new-model
!
resource policy
!
memory-size iomem 15
clock timezone GMT+1 1
clock summer-time SUMMER-TIME recurring last Sun Mar 2:00 last Sun Oct 3:00
mmi polling-interval 60
no mmi auto-configure
no mmi pvc
mmi snmp-timeout 180
voice-card 1
!
voice-card 2
!
ip subnet-zero
!
!
no ip dhcp use vrf connected
!
!
ip cef
ip name-server 62.211.69.150
ip name-server 212.48.4.15
no ip ips deny-action ips-interface
!
no ftp-server write-enable
!
!
!
voice service voip
sip
!
!
voice class codec 1
codec preference 1 g711alaw
codec preference 2 g711ulaw
codec preference 3 g729r8
!
voice source-group casa
access-list 1
!
username yyyy password xxxx
!
no crypto isakmp ccm
!
interface ATM0/0
no ip address
no atm ilmi-keepalive
dsl operating-mode auto
pvc 8/35
encapsulation aal5mux ppp dialer
dialer pool-member 1
!
interface FastEthernet0/0
ip address 10.154.24.1 255.255.255.0 secondary
ip address 192.168.1.1 255.255.255.0
ip nat inside
ip virtual-reassembly
speed auto
no cdp enable
hold-queue 100 out
!
interface Dialer0
ip address negotiated
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
ppp chap hostname xxxx
ppp chap password yyyy
ppp pap sent-username xxxx password yyyy
!
ip classless
ip route 0.0.0.0 0.0.0.0 Dialer0
no ip http server
ip http access-class 2
no ip http secure-server
!
ip nat service sip udp port 5061
ip nat inside source list 1 interface Dialer0 overload
!
!
access-list 1 permit 192.168.1.0 0.0.0.7
access-list 2 permit 192.168.1.0 0.0.0.7
!
!
control-plane
!
!
voice-port 1/0
echo-cancel coverage 32
no vad
cptone IT
timeouts wait-release 15
bearer-cap Speech
caller-id enable
!
voice-port 1/1
echo-cancel coverage 32
no vad
cptone IT
timeouts wait-release 15
bearer-cap Speech
caller-id enable
!
dial-peer voice 31 pots
destination-pattern nnnnnnn !--- numero assegnato
port 1/0
!
dial-peer voice 32 pots
destination-pattern 32
port 1/1
!
dial-peer voice 10 pots
destination-pattern 0.
port 2/0
!
dial-peer voice 11 pots
destination-pattern 1.
port 2/1
!
dial-peer voice 50 voip
destination-pattern 5.
voice-class codec 1
session protocol sipv2
session target sip-server
session transport udp
dtmf-relay sip-notify
!
sip-ua
authentication username nnnnnnn password xxxxx
retry invite 4
retry response 3
retry bye 2
retry cancel 2
registrar ipv4:212.97.59.76:5061 expires 3600
sip-server ipv4:212.97.59.76:5061
!
!
telephony-service
max-conferences 4 gain -6
!
line con 0
exec-timeout 120 0
transport output pad udptn telnet rlogin ssh
stopbits 1
speed 38400
line aux 0
transport output pad udptn telnet rlogin ssh
line vty 0 4
access-class 2 in
exec-timeout 30 0
password xxxx
login local
line vty 5 7
access-class 2 in
exec-timeout 30 0
password xxxx
login local
!
spero di non avervi annoiato
