Pagina 1 di 1

IPV6 stateless autoconfiguration - NDP - Stateless DHCP

Inviato: lun 11 giu , 2012 4:40 pm
da cami
Good morning at all,
anybody can help me to understand, in ICND2 book Official Exam Certification Guide
Second Edition
of Wendell Odom, ipv6 chapter 17 question 5, about stateless autoconfiguration:

question 5
Which of the following help allow an IPv6 host to learn the IP address of a default
gateway on its subnet?
a. Stateful DHCP
b. Stateless RS
c. Stateless autoconfiguration
d. Neighbor Discovery Protocol

I answered A and C, but the book write A and D: why the C is not valid ?
A host that uses stateless autoconfiguration can learn its IPv6 address and prefix automatically, as
well as learn its default router IP address, in both cases using NDP RS/RA messages (page 599).

For the same reason the question n. 4:
Which of the following answers list either a protocol or function that can be used by a
host to dynamically learn its own IPv6 address?
a. Stateful DHCP
b. Stateless DHCP
c. Stateless autoconfiguration
d. Neighbor Discovery Protocol

the answer A and C would not correct, it would be: A and D, where the NDP is always used.

Thank you in advance.

Re: IPV6 stateless autoconfiguration - NDP - Stateless DHCP

Inviato: mer 13 giu , 2012 11:00 am
da carini
cami ha scritto:Good morning at all,

question 5
Which of the following help allow an IPv6 host to learn the IP address of a default
gateway on its subnet?

Thank you in advance.
I think that the key is in the word "learn" which implies that you have to learn from somewhere