File di boot per AG1232....
Inviato: mer 19 set , 2007 5:18 pm
Mi sono trovato in questa spiacevole situazione? Non so più che fare....
Qualcuno può aiutarmi?Dove trovo questi file?
Xmodem file system is available.
flashfs[0]: 4 files, 1 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 7741440
flashfs[0]: Bytes used: 5632
flashfs[0]: Bytes available: 7735808
flashfs[0]: flashfs fsck took 11 seconds.
Reading cookie from flash parameter block...done.
Base ethernet MAC Address: 00:1a:6c:17:8d:de
Initializing ethernet port 0...
Reset ethernet port 0...
Reset done!
ethernet link up, 100 mbps, full-duplex
Ethernet port 0 initialized: link is up
The system is unable to boot automatically because there
are no bootable files to boot.
C1200 Boot Loader (C1200-BOOT-M) Version 12.3(2)JA4, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Compiled Mon 13-Jun-05 15:39 by ssearch
ap:
Qualcuno può aiutarmi?Dove trovo questi file?
Xmodem file system is available.
flashfs[0]: 4 files, 1 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 7741440
flashfs[0]: Bytes used: 5632
flashfs[0]: Bytes available: 7735808
flashfs[0]: flashfs fsck took 11 seconds.
Reading cookie from flash parameter block...done.
Base ethernet MAC Address: 00:1a:6c:17:8d:de
Initializing ethernet port 0...
Reset ethernet port 0...
Reset done!
ethernet link up, 100 mbps, full-duplex
Ethernet port 0 initialized: link is up
The system is unable to boot automatically because there
are no bootable files to boot.
C1200 Boot Loader (C1200-BOOT-M) Version 12.3(2)JA4, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Compiled Mon 13-Jun-05 15:39 by ssearch
ap: