attualmente ho la seguente configurazione (ho cambiato gli indirizzi ip quindi facciamo finta che 10.0.0.x siano ip pubblici)
Ora io vorrei cambiare l'ip dell'interfaccia eth0 e dargli un ip privato... quindi dovrebbe diventare così (facendo questo chiaramente perdo gli ip aggiuntivi...)interface Ethernet0
ip address 10.0.0.22 255.255.255.248
no ip redirects
no ip unreachables
no ip proxy-arp
no cdp enable
hold-queue 100 out
!
interface ATM0
no ip address
ip access-group 100 in
ip access-group 103 out
no ip redirects
no ip unreachables
no ip route-cache
no atm ilmi-keepalive
dsl operating-mode auto
!
interface ATM0.1 point-to-point
bandwidth 2048
ip address 10.0.0.66 255.255.255.252
ip access-group 100 in
ip access-group 103 out
no ip redirects
no ip unreachables
no ip route-cache
pvc 8/35
protocol ip 10.0.0.67 broadcast
encapsulation aal5snap
!
!
ip nat inside source list 1 interface ATM0.1 overload
ip classless
ip route 0.0.0.0 0.0.0.0 ATM0.1
no ip http server
!
!
access-list 1 permit any
access-list 23 permit any
però se faccio questo i pc all'interno della rete non escono su internet... qualcuno sa dirmi dove sbaglio!?!?interface Ethernet0
ip address 192.168.0.1 255.255.255.0
no ip redirects
no ip unreachables
no ip proxy-arp
no cdp enable
hold-queue 100 out
!
interface ATM0
no ip address
ip access-group 100 in
ip access-group 103 out
no ip redirects
no ip unreachables
no ip route-cache
no atm ilmi-keepalive
dsl operating-mode auto
!
interface ATM0.1 point-to-point
bandwidth 2048
ip address 10.0.0.66 255.255.255.252
ip access-group 100 in
ip access-group 103 out
no ip redirects
no ip unreachables
no ip route-cache
pvc 8/35
protocol ip 10.0.0.67 broadcast
encapsulation aal5snap
!
!
ip nat inside source list 1 interface ATM0.1 overload
ip classless
ip route 0.0.0.0 0.0.0.0 ATM0.1
no ip http server
!
!
access-list 1 permit any
access-list 23 permit any
GRAZIE!
