CiscoForums.it

Non riesco a resettare la password di un router 1721 che mi sono procurato
per smanettare un poco.

All'avvio faccio CTRL+BREAK ma il router non se ne frega va avanti per la sua strada
e continua a fare il suo boot. Questo è quello che succede.

Avete qualche suggerimento? Mi serve perché vorrei esercitarmi per una prova laboratorio.

Grazie


System Bootstrap, Version 12.2(7r)XM2, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2003 by cisco Systems, Inc.
C1700 platform with 98304 Kbytes of main memory

program load complete, entry point: 0x80008000, size: 0x7ddd68
Self decompressing the image : #################################################
################################################################################
##### [OK]


Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
MainBoard 0X00027A80 1721
0X000F3BB0 public buffer pools
0X00211000 public particle pools
0X0002 0X0000DC00 Card in slot 0
TOTAL: 0X0033A230

If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.



Allocating additional 12901906 bytes to IO Memory.
PMem allocated: 84377534 bytes; IOMem allocated: 16285762 bytes

Restricted Right

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706



Cisco Internetwork Operating System Software
IOS (tm) C1700 Software (C1700-SY7-M), Version 12.3(6c), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Tue 20-Jul-04 07:00 by kellythw
Image text-base: 0x80008120, data-base: 0x80DBFC64

cisco 1721 (MPC860P) processor (revision 0x400) with 82399K/15905K bytes of memo
ry.
Processor board ID FOC08320AMH (3226108074), with hardware revision 0000
MPC860P processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
1 Serial(sync/async) network interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)



Press RETURN to get started!

A quel punto vuole
Utente e poi la password

Grazie infinite

Non so se hai già letto qui: http://www.areanetworking.it/index_docs ... uter_Cisco

E' una guida molto chiara e spiega il momento esatto in cui inviare la sequenza di Break.
Spero possa tornarti utile.

Ciao

panta

Probabilmente non è attivo il service di password-recovery, dai il break dopo l'[OK], hai poi qualche secondo in cui devi dare Y alla domanda "do you want to reset to factory default" o qualcosa di simile, e in questa maniera dovresti riuscire a resettare il router.

Self decompressing the image : #################################################
################################################################################
##### [OK] <Dare il break qui>