CiscoForums.it

Ho un problema che ci sto sbattendo la testa da un po' non riesco ad instaurare la punto a punto.. e mi ritrovo:


yourname#ping 37.207.185.58
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 37.207.185.58, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
yourname#show controller vdsl 0
Controller VDSL 0 is UP

Daemon Status: NA

XTU-R (DS) XTU-C (US)
Chip Vendor ID: 'BDCM' 'BDCM'
Chip Vendor Specific: 0x0000 0xA1F2
Chip Vendor Country: 0xB500 0xB500
Modem Vendor ID: 'CSCO' 'BDCM'
Modem Vendor Specific: 0x4602 0xA1F2
Modem Vendor Country: 0xB500 0xB500
Serial Number Near: GMK123800Y8 867VAE-K 15.1(4)M
Serial Number Far:
Modem Version Near: 15.1(4)M
Modem Version Far: 0xA1F2

Modem Status: TC Sync (Showtime!)
DSL Config Mode: AUTO
Trained Mode: G.992.5 (ADSL2+) Annex A
TC Mode: ATM
Selftest Result: 0x00
DELT configuration: disabled
DELT state: not running
Trellis: ON ON
Line Attenuation: 18.0 dB 11.3 dB
Signal Attenuation: 18.0 dB 10.8 dB
Noise Margin: 6.0 dB 7.5 dB
Attainable Rate: 23412 kbits/s 1141 kbits/s
Actual Power: 18.5 dBm 12.1 dBm
Total FECS: 509 0
Total ES: 0 0
Total SES: 0 0
Total LOSS: 0 0
Total UAS: 55 55
Total LPRS: 0 0
Total LOFS: 0 0
Total LOLS: 0 0
Bit swap: 333 4

Full inits: 1
Failed full inits: 1
Short inits: 1
Failed short inits: 0

Con questa configurazione:

vtp domain cisco
vtp mode transparent
username cisco privilege 15 secret 4 WfSPfeI2z2UGRawXTtfqb.p33QNqlEJKwm3mvGYjviA
username ccpuser privilege 15 secret 4 920vXmL/C1YOSXfIRCBhykAEdNU79Rvo7BJtJmzx/Xc
!
!
controller VDSL 0
!
!
!
!
!
!
!
!
!
!
interface ATM0
no ip address
no atm ilmi-keepalive
!
interface ATM0.1 point-to-point
ip address 37.207.185.58 255.255.255.252
ip nat outside
ip virtual-reassembly in
pvc 8/35
oam-pvc manage
oam retry 5 5 1
encapsulation aal5snap
!
!
interface Ethernet0
ip address 85.45.100.249 255.255.255.248 secondary
ip address 192.168.1.1 255.255.255.0
ip nat inside
ip virtual-reassembly in
no keepalive
hold-queue 100 out
!
interface FastEthernet0
no ip address
!
interface FastEthernet1
no ip address
!
interface FastEthernet2
no ip address
!
interface FastEthernet3
no ip address
!
interface GigabitEthernet0
no ip address
!
interface GigabitEthernet1
no ip address
shutdown
duplex auto
speed auto
!
interface Vlan1
description $ETH_LAN$
ip address 10.10.10.1 255.255.255.248
ip tcp adjust-mss 1452
!
ip forward-protocol nd
no ip http server
ip http access-class 23
ip http authentication local
no ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
!
!
ip nat pool inter 85.45.100.249 85.45.100.249 netmask 255.255.255.248
ip route 0.0.0.0 0.0.0.0 ATM0.1
!

In cosa sto sbagliando? Sicuramente ho sbagliato qualche configurazione.. ma non capisco..

HELP GazziNEt

prova a fare il debug atm:

debug atm packet

e posta qua, magari ci dice qualcosa di utile, poi mi sembra che il nat è incompleto, manca il comando ip nat inside source ecc....

.. Sono un po' arruginito.. ho attivato il debug ma ora negli 867 non c'e' più il ter mon per la visualizzazione del debug?

Perchè la cosa che non capisco è perché possa fallire la comunicazione atm:

Modem Status: TC Sync (Showtime!)
DSL Config Mode: ADSL2+
Trained Mode: G.992.5 (ADSL2+) Annex A
TC Mode: ATM
Selftest Result: 0x00
DELT configuration: disabled
DELT state: not running
Trellis: ON ON
Line Attenuation: 18.0 dB 4.6 dB
Signal Attenuation: 18.0 dB 10.9 dB
Noise Margin: 12.1 dB 13.2 dB
Attainable Rate: 19280 kbits/s 957 kbits/s
Actual Power: 18.7 dBm 12.3 dBm
Total FECS: 267 0
Total ES: 0 0
Total SES: 0 0
Total LOSS: 0 0
Total UAS: 114 114
Total LPRS: 0 0
Total LOFS: 0 0
Total LOLS: 0 0
Bit swap: 0 0

Full inits: 2
Failed full inits: 2
Short inits: 2
Failed short inits: 0

E sinceramente.. cosa ha sostituito ter mon ?

Saluti
GazziNet

forse non hai attivo il logging consol, abilitalo e vedi se va. Con sh logg vedi se ti ha dato messaggi di debug.