Faccendo un "sh controllers atm 0"
ottengo
ATU-R (DS) ATU-C (US)
Modem Status: Showtime (DMTDSL_SHOWTIME)
DSL Mode: ANSI T1.413
ANSI Issue/rev: 2/1 2/1
Vendor ID: 0x0022 0x0004
Capacity Used: 12% 45%
Noise Margin: 40.0 dB 26.0 dB
Output Power: 20.0 dBm 12.0 dBm
Attenuation: 20.0 dB 9.5 dB
Defect Status: None None
Last Fail Code: Message error
Selftest Result: 0x00
Subfunction: 0x15
Interrupts: 667 (1 spurious)
Activations: 4
Init FW: embedded
Operartion FW: embedded
SW Version: 3.9.220
FW Version: 0x1A04
Ma ATU-R (DS) e ATU-C (US) cosa sono e che valori rapresentano???
Grazie
noise e attenuazione sulle line adsl
Moderatore: Federico.Lagni
-
MaiO
- Messianic Network master
- Messaggi: 1083
- Iscritto il: sab 15 ott , 2005 10:55 am
- Località: Milano
- Contatta:
-=] MaiO [=-
-
MaiO
- Messianic Network master
- Messaggi: 1083
- Iscritto il: sab 15 ott , 2005 10:55 am
- Località: Milano
- Contatta:
Trovato
ATU-R
An ATU-R (ADSL Terminal Unit - Remote), sometimes called an "ADSL modem," is a hardware unit that is installed in any computer that uses a telephone company connection with Asymmetric Digital Subscriber Line (ADSL) service. The ATU-R connects to an Ethernet network interface card (NIC) in the computer and, on the other side, to a telephone jack in the home or business. Ideally (for less interference), the telephone jack hooks up to a new wire that goes to a signal splitter that the telephone company installs at the telephone company demarcation point (the place where the outside phone company wire or wires connect to the network of phone lines within the customer's building). The splitter divides the signal into low frequencies for voice and high frequencies for data.
ATU-C
(ADSL Transceiver Unit) A device that provides ADSL modulation of the telephone line. The device at the telco side is the ATU-C (Central), which is a line card plugged into the DSLAM. The unit at the customer's side is the ATU-R (Remote), which is either an external modem or a card plugged into the PC
Tnx cmq
ATU-R
An ATU-R (ADSL Terminal Unit - Remote), sometimes called an "ADSL modem," is a hardware unit that is installed in any computer that uses a telephone company connection with Asymmetric Digital Subscriber Line (ADSL) service. The ATU-R connects to an Ethernet network interface card (NIC) in the computer and, on the other side, to a telephone jack in the home or business. Ideally (for less interference), the telephone jack hooks up to a new wire that goes to a signal splitter that the telephone company installs at the telephone company demarcation point (the place where the outside phone company wire or wires connect to the network of phone lines within the customer's building). The splitter divides the signal into low frequencies for voice and high frequencies for data.
ATU-C
(ADSL Transceiver Unit) A device that provides ADSL modulation of the telephone line. The device at the telco side is the ATU-C (Central), which is a line card plugged into the DSLAM. The unit at the customer's side is the ATU-R (Remote), which is either an external modem or a card plugged into the PC
Tnx cmq
-=] MaiO [=-
