paolomat75 ha scritto:L'interfaccia fisica è ATM0, ma avevo provato anche li e stesso errore.
Non va neanche
nel pvc del atm
.
Ora esco. Stasera mi ci metto dietro.
Grazie
Paolo
non puoi mettere una policy-map su un pvc ubr.
sotto "config-if-atm-vc#" cosa hai? io per esempio ho:
ghira(config-if-atm-vc)#?
ATM virtual circuit configuration commands:
auto Configure Automation
broadcast Pseudo-broadcast
cbr Configure Constant Bit Rate (CBR) Service
class-vc Configure default vc-class name
default Set a command to its defaults
description Configure a string description for this vc
dialer set dialer pool this pvc belongs to
encapsulation Select ATM Encapsulation for VC
exit-vc Exit from ATM VC configuration mode
idle-timeout Set idle time for disconnecting this SVC/AutoVC
ilmi Configure ILMI management
inarp Change the inverse arp timer on the PVC
ip Assign an ip address to the atm interface through ATMInarp
no Negate a command or set its defaults
oam Configure oam parameters
oam-pvc Send oam cells on this pvc
ppp Point-to-Point Protocol
pppoe PPPoE options
pppoe-client pppoe-client
protocol Map an upper layer protocol to this connection.
radius Override radius behaviour for VC
rx-speed Incoming connection speed of VC for L2TP reporting
service-policy Attach a policy-map to a VC
tx-ring-limit Configure PA level transmit ring limit
ubr Configure Unspecified Bit Rate (UBR) for this interface
ubr+ Enter Peak Cell Rate(pcr)Minimum Cell Rate(mcr) in Kbps.
vbr-nrt Enter Variable Bit Rate (pcr)(scr)(bcs)
vbr-rt Enter Variable Bit Rate (pcr)(average)
vc-hold-queue Configure hold queue size
vpn Configure VPN parameters
.