ASA 5505 NAT

[pivellocheimpara]

Buongiorno a tutti.
Ho configurato un asa 5505 (8.0.2) in questo modo:

: Saved
:
ASA Version 8.0(2)
!
hostname xxxxxxxx
enable password xxxxxxxxxxxxxx encrypted
names
!
interface Vlan1
nameif inside
security-level 100
ip address 10.10.xx.yy 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address xxx.xxx.xxx.xxx 255.255.255.0
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
passwd xxxxxxxxxxxxxxxx encrypted
ftp mode passive
object-group protocol TCPUDP
protocol-object udp
protocol-object tcp
access-list inside_nat0_outbound extended permit ip any 10.10.xx.yyz 255.255.255.224
access-list outside_nat0_outbound extended permit tcp any host xxx.xxx.xxx.xxx eq 200
pager lines 24
logging enable
logging asdm informational
mtu inside 1500
mtu outside 1500
ip local pool test_pool 10.10.xx.xxx-10.10.xxx.xxx mask 255.255.255.xxx
icmp unreachable rate-limit 1 burst-size 1
asdm image disk0:/asdm-602.bin
no asdm history enable
arp timeout 14400
global (outside) 1 interface
nat (inside) 0 access-list inside_nat0_outbound
nat (inside) 1 0.0.0.0 0.0.0.0
static (inside,outside) tcp ip_pubblico 200 ip_privato 200 netmask 255.255.255.255 dns
access-group outside_nat0_outbound in interface outside
route outside 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout uauth 0:05:00 absolute
dynamic-access-policy-record DfltAccessPolicy
aaa authentication ssh console LOCAL
aaa authentication telnet console LOCAL
http server enable
http 10.10.xx.zzz 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
crypto ipsec transform-set ESP-3DES-SHA esp-3des esp-sha-hmac
crypto ipsec transform-set ESP-AES-256-MD5 esp-aes-256 esp-md5-hmac
crypto ipsec transform-set ESP-DES-SHA esp-des esp-sha-hmac
crypto ipsec transform-set ESP-DES-MD5 esp-des esp-md5-hmac
crypto ipsec transform-set ESP-AES-192-MD5 esp-aes-192 esp-md5-hmac
crypto ipsec transform-set ESP-3DES-MD5 esp-3des esp-md5-hmac
crypto ipsec transform-set ESP-AES-256-SHA esp-aes-256 esp-sha-hmac
crypto ipsec transform-set ESP-AES-128-SHA esp-aes esp-sha-hmac
crypto ipsec transform-set ESP-AES-192-SHA esp-aes-192 esp-sha-hmac
crypto ipsec transform-set ESP-AES-128-MD5 esp-aes esp-md5-hmac
crypto dynamic-map SYSTEM_DEFAULT_CRYPTO_MAP 65535 set pfs
crypto dynamic-map SYSTEM_DEFAULT_CRYPTO_MAP 65535 set transform-set ESP-AES-128-SHA ESP-AES-128-MD5 ESP-AES-192-SHA ESP-AES-192-MD5 ESP-AES-256-SHA ESP-AES-256-MD5 ESP-3DES-SHA ESP-3DES-MD5 ESP-DES-SHA ESP-DES-MD5
crypto map outside_map 65535 ipsec-isakmp dynamic SYSTEM_DEFAULT_CRYPTO_MAP
crypto map outside_map interface outside
crypto isakmp enable outside
crypto isakmp policy 10
authentication pre-share
encryption 3des
hash sha
group 2
lifetime 86400
no crypto isakmp nat-traversal
no vpn-addr-assign dhcp
console timeout 0
management-access inside
!

threat-detection basic-threat
threat-detection statistics port
threat-detection statistics protocol
threat-detection statistics access-list
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect netbios
inspect rsh
inspect rtsp
inspect skinny
inspect esmtp
inspect sqlnet
inspect sunrpc
inspect tftp
inspect sip
inspect xdmcp
!
service-policy global_policy global
group-policy Gr11 internal
group-policy Gr11 attributes
vpn-tunnel-protocol IPSec
username ccccccc password ccccccccccccc encrypted privilege 15
tunnel-group Gr11 type remote-access
tunnel-group Gr11 general-attributes
address-pool gr_pool
default-group-policy Gr11
tunnel-group Gr11 ipsec-attributes
pre-shared-key *
prompt hostname context


Ho 2 problemi di questo genere:

1. Non riesco ad accedere alla macchina interna sulla porta 200;
2. Non funziona la connessione ssh mentre quella telnet sì;

Quanche idea?
Ho usato una configurazione simile anche per un altro asa 5505 (7.2) e funziona correttamente.

Grazie

PcI

[pivellocheimpara]

Grazie a tutti ma ho risolto da solo.

Mai mollare....

PcI